Wuyi Xinxie Industry and Trade Co., Ltd.
Add:Zhejiang Wuyi hardware and machinery industrial park
Tel:0086-579-89086963
Fax:0086-579-89086917
Email:sales@weiduntools.com
www.weiduntools.com |
|
Proper use of the drill |
An engine start 1. Preparation before start Check engine oil level, the engine is placed in a horizontal position, and clean around the oil filler. Remove the dipstick, wipe off the oil with a clean cloth and then reinsert the end of oil, Note: The engine oil level is too low, it will cause engine failure; but oil should not exceed the scale, too much oil will cause power loss and smoke. Check the air filter cartridge is blocked, If necessary, must be maintained. Note: Never use the engine without the air cleaner, otherwise, it will accelerate engine wear. Check the fuel tank of fuel, be sure to use pure gasoline. 2. Start and flameout When the engine is started, the fuel should switch to the open position, the choke switch to the choke position. Note: If the engine is hot or high air temperature, do not use the choke, Throttle position should pull to quickly position start. Will start to gently pull the rope to start, until you feel resistance and then quickly pull there. Move the throttle to the stop position, and then the fuel switch to the off position. Second, the use of punch attention problems 1. The need for drilling of lawn, will likely cause dangerous accidents stones, wire and other items cleaned before starting work. 2. Before drilling on the lawn sprinkler in order to achieve the desired drilling results. 3. For lawn sprinklers, wires and other items needed to do to avoid the mark, to prevent work touches. 4. Children should stay away from drilling machine. 5. Before work to check the gearbox oil. 6. The rear wheel is in the lowest position. 7. OK belt tensioning clutch Millia. 8. Start the engine, the operator adjust the throttle to normal walking speed, so that the operator can control the machine is always comfortable. 9. May not work on slopes steeper than 30 degrees. 10. When the machine is running, shall be placed in the hands or feet near moving or rotating parts available. 11. During the operation to prevent the opening drive guard unit. 12. Not tamper with various configurations lawn drilling machines. 13. For no other ground operations except the lawn outside. |
|
|
|
|